Where is reset button on TiVo remote?

Step 6: Try resetting the remote control address so that it will control any box. To reset the remote control address: Hold down the PAUSE and TiVo buttons for 5 seconds, until the red light (amber light for Premiere remotes) on the remote comes on. Use the number buttons to enter 0.

Why isn’t my TiVo working?

Power cycle your TiVo device, modem and router. Unplug your modem and router then wait 10 seconds and plug them back in. A full restart can take 30-60 seconds. Unplug your TiVo device’s power cord for 20 seconds, then plug it back in.

Why wont my TiVo connect?

Verify that your Ethernet cable is securely plugged in between your modem and router. Ensure that all connections are securely plugged into the TiVo box, wireless adapter, and any additional equipment used to connect your box to the Internet. Unplug your modem and router then wait 10 seconds and plug them back in.

Why is my TiVo box stuck on starting up?

Unplug the box for 15 seconds, and then plug it back in again. If you still have the issue, connect your cable box directly to your TV. Reconnect the cable box to the TiVo box. If the image is frozen again, contact TiVo Customer Support.

How do I reset my TiVo app?

When the second cycle is completed:

Access TiVo Central.
Select Menu.
Select Help.
Select Restart Box.
Press the Thumbs Down ? button three times.
Wait until restart is complete.

What do I do if my TiVo remote doesn’t work?

If the TiVo remote hasn’t been set up to control your TV, press the Input or Source button on the TV’s remote control until you see TiVo Central/HOME. If the TV remote does not have one of these buttons, refer to the TV’s manual on how to change the input setting. 3. If you still don’t see TiVo Central or HOME All the connections must be secure. 4.

Can a bad power supply cause a TiVo not to work?

If a power supply is bad, it is very common to see a TiVo fan continue to spin. Similarly, in some models, if a TiVo has lights lit on the front but has no video output at all (not even the “Welcome Powering Up” screen), then that, too, can be indicative of a bad power supply.

Why are there no lights on the front of my TiVo?

As a general rule, no lights on the front indicates a power supply failure. The power supply may be strong enough to power the fan, but will not send power to the front panel. Your hard drive may or may not be spinning. Here is some additional information about TiVo power supply troubleshooting.

How do you turn off the backlight on TiVo?

Hold down the PAUSE and TiVo buttons for 5 seconds, until the red light (amber light for Premiere remotes) on the remote comes on. Use the number buttons to enter 0. A remote control set to remote address 0 will control any box. Step 7: Turn off your TV’s backlight function.

Why are my channels not showing on my TiVo?

A failed activation is the most common reason why channels are not visible after CableCARDs are installed. Use the troubleshooting procedures below to determine what else might be causing the problem if the CableCARD was successfully installed, activated or paired.

What should I do if my TiVo DVR says no dial tone?

If the drive spins up with the IDE cable out, you need a chip repair. Contact weaKnees for repair costs. The part you need largely depends on the pattern of lights and the TiVo model. Generally, this is not a common symptom on DIRECTV TiVo DVRs. Contact weaKnees for assistance and repair Error: “Failed. No Dial Tone” Error: “Failed.