How do you test zones on a Hunter sprinkler system?

How do you test zones on a Hunter sprinkler system?

To initiate the test program:

1. Press and hold the PRG button. The station number will be flashing.
2. Press the or button to scroll to the station you would like the test program to start with. Use the and buttons to set a run time of up to 15 minutes.
3. After a 2 second pause, the test program will begin.

Why are the zones not the same on Hunter Pro-C?

If you’re trying to set two different times for two different valves in A, that’s your problem there. The start time numbers are not zone numbers. If you set zone 1 for 10 minutes and zone 2 for 10 minutes, and set start time 1 for 10am and start time 2 for 6am, both zones will run consecutively at both of those times.

How to troubleshoot a Hunter Pro C sprinkler system?

Check AC power wiring. Correct any errors. Make sure slide bar is in “Power On” position. Install 9v battery inside panel, if still no display replace Pro-C panel. The display reads “SP ERR”. Electrical noise is entering the system.

How to bypass rain sensor on Hunter sprinkler system?

Slide the Rain Sensor switch on front panel to the BYPASS position to bypass rain sensor circuit, or install the sensor jumper. Rain sensor will not shut off system. Incompatible rain sensor or the jumper was not removed when sensor was installed. Manual Single Station Mode Used. Make sure sensor is micro-switch type such as Mini-Clik®.

How to set station run times on Hunter Pro C?

Step 5 Slide the black bar back to Power On or Locked Position. Step 6 Press the RESET button on the backside of the controller door. Turn the dial to SET STATION RUN TIMES / RUNT TIMES and press the right arrow to see if controller recognizes all station modules installed on controller.

Why is Zone 1 not working on Hunter Pro C?

About a month ago, I noticed that zone 1 no longer turns on, but zone 2, 3, and 4 do. On the Hunter Pro C screen, it shows like zone 1 is working, but I do not hear any water flow, and the sprinklers do not pop up. I looked behind the screen to see if there were any loose connections, but do not see any.

Why does no water flow on Hunter Pro C?

An OL or 1 value is a broken wire or open loop and the watering icon will flash but the valve won’t open so no water will flow. Pic #2 – Push the gray bar up and down to lock and unlock, reseat the modules.

Why is one zone of my sprinkler system not working?

Each zone consists of several sprinkler heads controlled by a valve that is electrically activated. If a single zone is not working, the problem is usually an electrical issue or a defective

Why are my Pro C sprinklers not working?

Pro-C – Sprinklers Not Watering If your controller shows irrigation running (Flashing Sprinkler Icon), and your sprinklers are not working, you may have a wiring problem at the valves or the irrigation water supply has been shut down.