How do you remove the head of a clipper?
Pull the trimmer line spool out of the trimmer head. Observe your trimmer head to see if it has a small hole in the inner and outer portions. If so, insert a small Phillips screwdriver into the two holes to hold it in position, remove the center nut with an adjustable wrench and pull the head off.
How to replace the Weed Eater line and spool?
How to Replace the Weed Eater Line and Spool | DoItYourself.com A weed eater line allows the weed eater to trim your yard the way it should. DIY Home Forums New Posts
How do you remove the spool from a craftsman Weedeater?
Press the spool into the hub until it snaps and pull the loose line from the notch. Turn the trimmer over so the tap button on the bottom is facing up. Press the spool into the hub until it snaps and pull the loose line from the notch.
What to do if your Weed Eater is stuck on the end?
The line needs to be wound tightly around the spool, with even rows and layers. If the line overlaps and crisscrosses itself or comes loose while the spool is spinning, the spool will also stop spinning. Open up the head cap, pull out the spool and remove all cutting line.
What’s the best way to remove a spool from a Toro Trimmer?
Reset the spring before reinserting the spool as directed in the owner’s manual for your specific Toro electric trimmer. Never soak or submerge the cutting head, cap and spool to clean away debris. Instead, use a soft-bristled brush or a damp cloth.
How do you clean a weed eater 1214?
Unplug the Weed Eater 1214 from the electrical outlet to prevent accidental operation while working. Position the trimmer so the bottom of the trimmer head is easily accessible. Wipe any accumulated grass or debris from the trimmer head with a rag. Locate the round tap button in the center of the head.
How does a weed eater 1214 string trimmer work?
The Weed Eater 1214 electric string trimmer is a lightweight design that helps control grass and weeds in hard-to-reach areas where a lawn mower won’t fit. Periodic maintenance includes installing new trimmer line when the old line wears down through normal use.
Reset the spring before reinserting the spool as directed in the owner’s manual for your specific Toro electric trimmer. Never soak or submerge the cutting head, cap and spool to clean away debris. Instead, use a soft-bristled brush or a damp cloth.
How do you replace the string on a weed eater?
Cut a 25-foot length of trimmer string for installation onto the old spool. Place the tip of the string into the center cavity of the spool and then tightly wrap the string around the spool counterclockwise until you have approximately 4 to 6 inches of string left off the spool.
